I have purchased HP Proliant microserver N40L with 2 Seagate 3TB HDD for RAID1 configuration. I configured RAID1 from the bios utility and installed Server 2012. After the 1st clean install, I went and checked my RAID drives and It surprised by when I saw two separate 3TB hard drives in the disk management, Disk-2 is allowing me to create a GPT parition and Disk-1 is completely unaccessible. Ideally, Windows should have now shown me two separate drives at all in the hardware RAID1 mode. I tried lot of fixes without success, I even tried windows 2012 Essential hoping it might fix the probelm
I than install Windows 7 to check if it is my hardware, and to my surprise it worked, it showed me a one 3 TB drive and allowed me to create a one GPT parition of all full size, I copied some files and tested a fail safe scenario removing single hard drive and restarting and accessing those files.
I have also checked this in WHS 2011 without any problem
I now giving up, I don't understand why windows server 2012 has problem with my 3 TB disks. Windows 7 and WHS 2011 are older and I was thinking they would have problems with my 3 TB hard drives instead, they worked fine and Server 2012 is giving me a trouble, inpiste of being a new windows server OS
Immediate help will be appreciated
Thanks