Hello All,
I read an article http://blogs.technet.com/b/askds/archive/2009/07/16/configuring-dfsr-to-a-static-port-the-rest-of-the-story.aspx
to configure DFSR with static EPM port. I ran the command dfsrdiag /staticrpc /port:55555 /mem:server on our server A and then with Server B.
Now DFSRDIAG DUMPMACHINECFG on both servers show rpcportassignment as 55555.
When i took captures between two servers, I dont see 55555 anywhere but other high EPM ports.
I was under impression that once I run the command on this server. A will use any higher port and B will respond on 55555 and then both will use 55555.
Can anyone share expected behaviour of this command.
~Cheers, Rohit Kochher